Asian Power Control

Panels

1

APFC Panel

Automatic Power Factor Control or APFC Panels are mainly used for the improvement of Power Factor. Power Factor is the ratio of active power to apparent power and it is a major component in measuring electrical consumption. APFC is an automatic power factor control panel which is used to improve the power factor, whenever required, by switching ON and OFF the required capacitor bank units automatically.

2

Power Control Centre

Switchboard assemblies used for low voltage power distribution are mostly called Power Control Centres. These PCC controls, monitor & provide continuous supply to connected loads through breakers. If something goes wrong with the power source or load, the power control centre fitted with breakers cut down supply to the affected portion and the rest of the system stays healthy.

3

Motor Control Centre

Switchboard assemblies used for low voltage power distribution having a common power bus and principally containing motor control units are generally called motor control center (MCC). The Motor Control Centre takes care of controlling, monitoring & recording of the power supplied to motors.

4

LT Panel and HT Panel

LT Panel is an electrical distribution board that receives power from generator or transformer and distributes the same to various electronic devices and distribution boards. Such panels are used in industries both for internal and external use and, therefore, they are quite rugged to withstand different climatic conditions. Our LT panels are designed to work with low electricity consumption that makes them cost effective

5

AMF Panel

An AMF panel will enable this automatic changeover. Automatic mains failure (AMF) panels, often referred to as automatic transfer switch (ATS) panels, make the power switch to emergency standby generators in the event of a significant loss of mains power or total blackout.

6

ACB Panel

Air Circuit Breaker (ACB) is an electrical device used to provide Overcurrent and short-circuit protection for electric circuits over 800 Amps to 10K Amps. These are usually used in low voltage applications below 450V. … The air circuit breakers have completely replaced oil circuit breakers.

7

Local Distribution Board

These are designed to control the speed of electric motor and feed pump. They are widely used in drilling, pumping and other large machine applications. The VFD panels are widely used in tube mills, paper mills, extruder plants, rolling Mills, cable industry and CTL Lines. They are even installed in hospitals, business houses and other public places. VFD control panel are designed to match variable speed requirements of a process unit and so are vigorously tested on various speed parameters.

8

VFD Control Panels

VFD Control Panel is designed to control the speed of the electric motor and feed pump. They are widely used in drilling, pumping, and other large machine applications. the control panel is designed to match variable speed requirements of a processing unit and so are rigorously tested on various speed parameters.

9

Lighting Control Panels

We can design and supply Distribution & Lighting Control Panels, which find application in plants for distributing power in the lighting system, keeping in mind the specific requirements of the clients.

10

Feeder Pillars

Switchboard assemblies that provides local isolation to electrical distribution equipment, protecting both the cabling and the transformer from faults. Feeder pillars allow simple and local maintenance to your equipment, reducing site downtime and reducing overall maintenance costs.

    WhatsApp WhatsApp us
    Call Now Button